Battery, Starter/Alternator Cable for 1988 Mercedes-Benz 560SEL

Description: 100 ah. Secondary, with dual battry pkg. FILLED. 12V/100AH
Volt: 12V
Amps: 100AH
Gefahrgutkennzeichen: 8.1 Corrosive substances (batteries filled with acid).

Description: To 001 541 79 01. For uncharged battery 72 ah, 74 ah. 66 ah.

Description: From battery to cable connector.

Description: From expansion valve to compressor. Return line thru fire wall. Feed line to fire wall. For fuel hose through wall, spare wheel recess. For starter cable through partition wall. (starter cable through pedal floor). (to seal vacuum connection at ate booster brake). Hose thru fire wall.

Description: 4MM. 4.0mm2. Fan. 4.0mm2. TO 008 545 10 28. 4.0mm2.

Description: Belt locking retractor feed-in. Speed signal. 1-pin. Cockpit cable harness. 1-pin. From electrical compartment plugconnection to indicating instruments. 1-pin. Plug connection kl 87 ug. 1-pin. Temperature sensor refrigerant indicator. 1-pin. Temperature switch,16 degs.. 1-pin. Used without automatic air conditioner. 1-pin.

Description: To 014 545 07 28.

Description: Cable to terminal b+. Neg. Cable to battery.

Description: Pos. Cable to starting motor.

Description: Starting cable thru unit partition panel.

Description: M8-10
Diameter: 8mm
Strength / hardness class: 10
Thread code letter: M
Thread pitch: 1,25mm
Width across flats: 13mm. Cable to starting motor,terminal 30. Horn to bracket.

Description: Cd changer to bracket. Mounting at console. Control module mounting.

Description: Positive cable to side member.

Description: Front fender to wheelhouse bracket. 4.8x13. Partition panel to fire wall,wheelhouse,connection support,and console. 4.8x13. Mounting, cover. 4.8x13. To 140 470 04 47. 4.8x13. Control unit. 4.8x13. Cooling pipe to side member and to engine cross member. 4.8x13. Line to upper rear wall. 4.8x13. High pressure line to subframe. 4.8x13. Screening below gear lever. 4.8x13. Heat shield mounting. 4.8x13.

Description: At battery frame.

Description: 3-pole. Spring dome. Cable connector to damper strut.

Description: 4-pole. At right side member.

Description: Pull rod to guide bearing.

Description: Cable to terminal b+. Positive cable to battery.

Description: Control module fastening driver seat. Control module mounting driver seat, left. Control module mounting driver seat, right. Control unit at backrest. Blinker sender unit mounting m4x14.

Description: Cables to cable connector. At front center stiffening. Blinker & tempomat switches to steering column jacket tube. Cable to resistor. Main cable harness to radiator baffle, right. Starting cable to cable connector.

Description: ELECTRONIC CABLE TO STARTING CABLE
Diameter: 6mm
Strength / hardness class: 8
Thread code letter: M
Thread pitch: 1mm
Width across flats: 10mm. POSITIVE CABLE TO BATTERY
Diameter: 6mm
Strength / hardness class: 8
Thread code letter: M
Thread pitch: 1mm
Width across flats: 10mm.

Description: From battery neg. Pole to ground. From battery to frame.

Description: From side member to engine.

Description: Main muffler suspension. M8x16. Central muffler suspension. Bracket on rear axle m 8x16.

Description: Wiper arm with blade to wiper spindle. Drive rod to crank arm. Wiper arm to wiper shaft. Wiper arm on spindle.

Description: For terminal at generator d pos. For terminal to generator d pos. Over interference suppressor terminals 61 and 87. Cap (over cable connection screw at generator, terminals d + and df). For cable harness at generator.

Description: Not filled.

Description: Not filled.

Description: Filled.

Description: Electric cable for 2 alternators.

Description: Electric cable for 2 alternators.

Description: For back-up light switch. Over interference suppressor, terminal 51. For reverse drive light switch. At top transmission case cover. Cap (for cable connection to stop light switch).

Description: TO 008 545 34 28/ 35 28/ 36 28. 0.5 MM2 FF6.3
Leitungsquerschnitt Min/Max: 0,5mm2
Oberflächenschutz PINs: Ag
Model 1: FF
Model 2: 6.3.

Description: Lighting of gear indicator. Lamp control. Tell-tale lamp airbag. Windshield-washer-fluid control. Shift gate illumination. Bipolar. Tell-tale lamp abs/asr. Pre-glow indicator. Tell-tale lamp 4-matic. (oxygen sensor exchange indicator).

Description: Filled. 92 ah.

Description: Filled. 12V/100AH. Cable harness mounting 12v/100 ah. 12v/100ah. Hybrid 100 ah. 12v/100ah.

Description: 100 amp. Filled. 12V/100AH. Hybrid 100 ah. 12v/100ah. Parts kit. 12v/100ah. With contents. 12v/100ah.